43003-01 6/15/2007
4
© 2007 Hunter Fan Company
3. The filter comes to you installed in the correct position. Grasp the filter, and pull it forward,
up, and out of the unit. Remove the plastic wrapping and replace the filter in the unit. The
white
HEPAtech
™ filter material should be facing outward (towards you).
4. Before closing the front cover, check the placement of the pre-filter. It is installed under
clips in the front cover. The pre-filter should be replaced every three months.
5. Close the front cover by once again pressing the buttons and allowing the front cover to
slip into place over the buttons. The unit is now ready for normal operation.
6. Plug the unit into a 240V electrical outlet.
7. Select a speed by sliding the speed selector to the appropriate location. The red power light
will be illuminated when you have selected a speed.
8. Turn the ionizer ‘on’, by sliding the ionizer switch to the ‘on’ position. The green light will
be illuminated when the ionizer is ‘on’.
NOTE:
The ionizer can release negative ions when the fan is not blowing. If it is used
consistenly without the fan, the dust particles that are attracted to the negative ions may
deposit on your walls and floors. To minimize these deposits, we recommend that you use
the ionizer only when the fan is blowing (when the unit is on lO, MEd, or hI speed).
Cleaning And Filter Replacement
1. Every few weeks, you should open the front grill and view the condition of the
HEPA-
tech
™ System Filter. Compare the filter to the color coded chart that is on the inside of
the housing. If the filter matches the dark color on the chart, you should remove the filter
and replace it with a new filter. BE SURE TO REMOVE THE PLASTIC WRAPPING
BEFORE PLACING THE NEW FILTER INTO THE AIR PURIFIER.
2. Clean the outside of the unit with a soft, damp cloth. The front grill can be removed and
cleaned in soapy water.
3. When you remove the front grill to clean it, you should also remove the pre-filter from the
front grill.
4. Be sure the front grill is completely dry before you reassemble it with the unit.
5. Model 36027 uses Filter #30917. No other filter or material should be used unless approved
by Hunter Fan Company.
