8
1886
1886
Installing the Glass
ON
Turn P
ow
er
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
WARNING
GLASS FALL HAZARD
To prevent
SERIOUS INJURY
or
DEATH
, make
sure that glass is properly secured.
Install the included bulb into
the socket. When necessary,
replace with bulb of same
wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Notch
Tab
Installing the Light Fixture
3 of 7
Fixture Screw
bag
Partially install three fixture screws, found
in the
hardware bag, into the posts as
shown, leaving the circled post empty.
Empty Post
Keyhole
Slot
Connect the plugs from the upper and
lower switch housings. Make sure to
line up the colored markings on the
connectors and that the connectors latch.
Align the three keyhole slots in the light kit
with the three assembly screws in the posts.
Lift the light kit and twist counterclockwise
to lock it into place. Be sure that both pull
chains are hanging freely.
Install the fourth fixture
screw and tighten all four
screws securely.
This is the screw you saved that
was attached to the red flag.
Fixture Screw
bag
1 of 7
Fixture
Screw
Ceiling Bracket
Downrod
Hanging Fan
Wiring
Canopy
Blades
Light
Glass/Bulbs
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.