7
44095-01 20101214
OperatIOn and adjustMents
Fan asseMBly (FIgure 4.)
Figure 4.
1.
Loosen the
Thumb Screw (K)
by turning it counterclockwise.
2.
Insert the
Internal Pole (O)
into the neck joint of the
Motor Housing (I)
and tighten by turning the
Thumb Screw
(K)
clockwise. Ensure it is tight enough to support the fan motor.
3.
Attach the
Misting Line Holder (N)
onto the
Internal Pole (O)
.
4.
Secure the
Misting Line (R)
to the clip under the
Front Grill (A)
and the
Misting Line Holder (N)
.
K
M
O
P
I
N
S
R
H
A
•
Place the fan on a level surface. Plug the GFCI plug into a standard 120-volt AC 3-Prong wall outlet.
•
Attach the
Valve (S)
onto a standard outdoor hose. Turn your water on at the spigot and use the lever on the
Valve
(S)
to turn water on and off.
•
To turn the fan on or adjust the speed setting, use the (H) high, (M) medium, (L) low, or (OFF) off buttons on the
lower part of the
Motor Housing (I)
.
•
To turn oscillation mode on, push the
Oscillation Knob (H)
. Pull the
OScillation Knob (H)
up to turn oscillation off.
•
Adjust the height of the fan by firmly gripping the
Internal Pole (O)
, loosening the
Height Adjustment Knob (P)
and adjusting the fan to the desired height. Fasten the
Height Adjustment Knob (P)
by turning it clockwise.
nOte:
always
ensure the
Waterproof Cover (M)
covers the
Height
adjustable knob (p)
after adjusting the
Internal
Pole (N)
.
•
To adjust the angle of the fan, turn the fan off and grasp the motor assembly firmly and tilt up or down.
caution
:
When not in use, turn the fan off and unplug it from the wall outlet. Turn the water off at the lever on the
Valve (S)
and at the water spigot and disconnect the
Valve (S)
from the hose.
gFcI Operation (Figure 5.):
The GFCI on the plug of this fan has 2 buttons: “Test” and “Reset”. If you wish to see if the GFCI circuit is functioning
properly press the “Test” button. The fan will immediately shut off as if the GFCI has been activated and the window
between the buttons will change to black. This lets you know the GFCI circuit has been activated. Press the “Reset”
button and the fan can be turned on again and the window between the buttons will show orange. This indicates the
GFCI circuit has not been activated and the fan should operate normally.
RESET
TEST
Figure 5.
Summary of Contents for 90397
Page 2: ......
