42935-0 06/04/2007
2
Go to
Section E -
Final Installation
on page 14.
Section D - Existing Construction – accessible from below
Remove one of the wiring access slugs on the top of the
housing. Use a second wiring access plug if needed.
EXISTING FAN
D3
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new fan
housing. If there is no existing fan choose an appropriate
location to make an ” x 9 5/8” opening.
Remove the mounting rail brackets.
3”
D4
Run the power supply wire through the strain relief, leaving
3” between the end of the wire and the strain relief. Tighten
the strain relief around the wire.
D1
D2
Summary of Contents for 42935-0
Page 18: ...42935 01 06 04 2007 18...