Coding switch
Forward/Reverse lever
Left/Right lever
19
Remote Control Operation
Matching the code :
Press the match code button until the LED is
blinking, then release the code button and press only
the match code button on the drive
board until the Led stops blinking and keeps in
light on status in just 1 seconds then it will be off, the
the LED keeps blinking over than 10 seconds , the
recoding is fail and will at last be off automatically ,
the reason may be that there is no electricity on the
drive board or the time interval between you press
the button on the remote control and on the drive
board is too long. To match the code again, please
release the code buttons and repeat above steps.
If the recode is fail, please turn off the power and then
turn on to recode. If it still couldn’t work, please
change a new remote –control and a new drive board.
Remote –control mode :Rider sits in the car, turns on
the power switch, set the manual / remote-control
switch at remote-control mode. Move the lever on the
2.4G remote-control to forward or reverse position,
the car will go forward or reverse accordingly, when
move the lever to left or right position, the car will go
to the left or right. The car will stop if the lever
released. The headlightwill on when the car moves
forward. There is no need to match the code when
replace the remotecontrol, motor control board or
mal-function of the remote-control, please match the
code again as Matching code steps.
Sleep mode:If you don’t operate the car in 8 hours
after you turn on the power switch, the car will shift to
sleep mode automatically. If you want to use the unit,
please turn the power switch off and restart it to acti-
vate.
Coding switch