Assembly Steps
7. Motor Hood assembly
8. Seat assembly
IMPORTANT SUPPLEMENT TO INSTRUCTION MANUAL
After assembling any wheel to the axles, please check the gap
between the screw thread and the collapsible (refer to below
picture), if the gap is too big, please add two or three washers inside
the wheel, But after tightening the nut outside the wheel, please turn
the wheel by your finger to check if the wheel can run smoothly, this
is very important, because if the wheel can run smoothly, it is ok, but
if the nut press the wheel and the wheel can’t run smoothly, the
motor will be broken easily! Then you need to decrease one or two
washers to make sure the wheel can run smoothly!
GAP
Motor hood
Seat
M5x12
machine screw
Ø3x12 screw
●
Fit the motor hood on the motor.
●
Tighten the
Ø
3x12 screws*3 to secure
it.
●
Insert the tabs on the seat into the slots
on the vehicle body.
●
Secure it with M5x12 screw*2 with a
screwdriver.
PLEASE NOTE: IN CASE OF PRODUCT FAULT DO NOT RETURN THIS PRODUCT TO STORE. PLEASE
CONTACT HUNTER PRODCUTS CUSTOMER SERVICE TOLL FREE NUMBER: 1800 224 094
OR VISIT WWW.ELECTRICRIDEON.COM.AU
-8-
