Assembly Steps
11. Install the Battery.
Loosen the battery cover screws of music box control and remove the cover. Insert two AA1.5V
batteries(See above photo). Replace battery cover .
non-rechargeable batteries are not to be recharged;
different type of batteries or new and used batteries are not to be mixed;
batteries are to be inserted with the correct polarity;
exhausted batteries are to be removed from the toy;
the supply terminals are not to be short-circuited.
rechargeable batteries are only to be charged under adult supervision;
rechargeable batteries are to be removed from the toy before being charged;
The transformers or battery charger used with the toy are to be regularly examined for damage to the cord,
plug, enclosure and other parts, and in the event of such damage, they must not be used until that damage
had been repaired.
IMPORTANT SUPPLEMENT TO INSTRUCTION MANUAL
After assembling any wheel to the axles, please check the gap
between the screw thread and the collapsible (refer to below
picture), if the gap is too big, please add two or three washers inside
the wheel, But after tightening the nut outside the wheel, please turn
the wheel by your finger to check if the wheel can run smoothly, this
is very important, because if the wheel can run smoothly, it is ok, but
if the nut press the wheel and the wheel can’t run smoothly, the
motor will be broken easily! Then you need to decrease one or two
washers to make sure the wheel can run smoothly!
FOR CUSTOMER SERVICE ENQUIRIES & SPARE PARTS
PLEASE CONTACT
HUNTER PRODUCTS TOLL FREE 1800 224 094
OR VISIT WWW.ELECTRICRIDEON.COM.AU
-9-