Motorized Shade Programming
NOTE: If you have more than one motorized shade,
they must be set them up individually. Apply power to one
unit, go through the setup sequence, then remove power.
If more than one unit is plugged in, each one will be
changed!
1
Turn power On
CHECK UP-DOWN SETTING
2
Press
and
simultaneously, hold until shade
jogs up and down
3
Press
- If shade goes up, go to next step, if not
press
for 5 seconds
(until shade jogs up and down, reverses direction)
SET DOWN LIMIT
4
Press
- Release when shade is at desired up
position
5
Press
and
until shade begins moving down
6
Press
when shade reaches desired down limit
7
Press
or
to fine tune lower limit position
8
Press
for 2 seconds to set lower limit
(shade does not jog)
TO RESET TOP LIMIT
1 Press
- Shade extends to top limit
2 Press
and
until shade jogs up and down
3 Press
or
to move shade to new position
4 Press and hold
for 2 seconds to set memory
TO SET INTERMEDIATE POSITION
1 Press
or
to move to the desired position
2 Press and hold
for 2 seconds (shade will jog)
TO DELETE INTERMEDIATE POSITION
1 Press
- Shade moves to intermediate position
2 Press and hold
for 2 seconds to erase position
(shade will jog)
ADD/DELETE A TRANSMITTER/CHANNEL
This process has also been pre-programmed by the
factory. If adding/deleting is necessary, proceed as
follows. Only one shade should have power. If more
than one unit is plugged in, each one will be changed!
TO ADD
a transmitter/channel, press the button on
an already recorded one until the motor jogs. Select the
transmitter/channel to add and press its button until it
jogs, then release.
TO DELETE
a transmitter/channel, press the button on
an already recorded one until the motor jogs. Select the
transmitter/channel to delete and press its button until it
jogs, then release.
STOP
Your limit settings have been changed.
Proceeding further will result in adding/
deleting a transmitter or channel.
© 2003 Hunter Douglas Inc. ® Registered trademark of Hunter Douglas Inc.
™Trademark of Hunter Douglas Inc. Patented in the U.S. and foreign countries.
U.S. and foreign patents pending.
LIT888245 10M 07/04
SET TOP LIMIT
9
Press
and
- Shade will start up
10
Press
when shade is in desired up position
11
Press
or
to fine tune top limit position
12
Press
for 2 seconds to set top limit
(shade will jog)
13
Press until shade jogs up and down to record
settings to memory
TO SET AN INTERMEDIATE POSITION
14
Press
or
to move shade to desired mid position
15
Press
to stop shade in desired position
16
Press and hold
until shade jogs up and down
TO RE-ENTER PROGRAMMING MODE
1
Power Off for 2 to 5 seconds*
2
Power On for 10 seconds*
3
Power Off for 2 to 5 seconds*
4
Power On
5
Shade jogs in one direction to indicate change to
program mode.
6
Press and hold for more than 7 seconds.
Shade will jog up and down after 1 second and again
after 7 seconds (shade will jog twice)
*Maintain time intervals closely
For assistance, call the Hunter Douglas
Customer Information Center at
1-888-501-8364
7:00 AM to 4:30 PM MST, Mon.-Fri.
Visit our Web site at hunterdouglas.com
Care and Cleaning
Normal cleaning of all Remembrance
®
window shades
requires only light dusting with a feather duster, soft cloth,
or low suction vacuum attachment. Do not clean with harsh
detergents.
