INSTALLATION
6
■
Attach the installation/extension brackets using the screws provided.
CAUTION:
The rear of the installation brackets must be flush
against a flat mounting surface. Do not mount installation
brackets on curved molding.
■
When using extension brackets, attach the installation brackets
using the screws and speed nuts provided.
Proceed to “Install the Shade” below.
Install the Shade
■
With the headrail slightly tilted,
insert the front lip of the headrail
onto the front lip of the installation
bracket.
■
Push the headrail back and
up until its bottom lip snaps
into bottom tab on the
installation bracket.
Attach the Optional Components
Standard Hold-Down Brackets
Standard hold-down brackets may be used with outside mount
shades only.
■
With the shade fully lowered, insert the pin on the hold-down
bracket into the hole on the bottom rail end cap.
■
Mark the hole locations on the mounting surface.
■
Position the hold-down brackets over the mounting hole
locations and check their alignment. Attach using two screws.
IMPORTANT:
Disconnect the bottom rail from the hold-down
brackets to raise the shade.
Insert Front
Lip of Headrail
onto Bracket
Bottom
Tab
Push Up
and Back
