DOUBLE-SIDED LAMINATION___________________________________________________________________
SET-UP
•
Follow the same webbing procedure as Encapsulating.
•
Mount the roll of prints on the roll easel attachment so that the images unwind facing up.
•
Center the roll of images in alignment with the rolls of film.
•
Use the footswitch to feed the images through the print guide table into the nip.
•
Once the prints are running through the rollers, set the brake tension on the roll easel attachment to exert a
significant amount of tension so the prints feed through without wrinkles. The type of laminate and graphics
being used will determine the amount of tension required.
•
Use the bottom rear wind-up tube to wind up the laminated prints. Tape the front edge of the first finished print to
a cardboard core placed over the tube and the prints will continue to automatically wind-up
•
Press the motor ON button and set the speed to 3 FPM or 1MPM to go into an effective Auto-run operation.
*
IMPORTANT:
Do not remove your foot from the footswitch until the motor is ON or the laminator will stop
affecting the finished output.
NOTE: With graphics in roll form, the edges are not completely sealed. Use an X-Acto ST Rotary
Cutter to quickly and efficiently trim your laminated images.