Humminbird SINGLEBEAM 405SX, Operation Manual

Page: 9 / 35

7
USING THE
405SX
SIMULATOR OPERATION
the DOWN ARROW until “Simulator” is
highlighted. When the screen times out, the
unit will be in simulator mode.
When in simulator operation, the 405SX
responds to control inputs as if it is in actual
operation, so feel free to experiment, or to
customize the unit for your particular
operation.
To exit Simulator mode, power the unit off.
FEATURE MEMORY
If your 405SX is installed with a transducer connected, any changes you make
to the set-up or User Options (see Control Functions) while in Simulator are
retained in the unit’s memory. This allows you to use simulator to experiment
with the various set-up options, and retain your selected settings for normal
operation.
If you are using the 405SX in Simulator when no transducer is connected, any
selected options are lost when the unit is powered off. The 405SX will return
to Factory Settings, or options selected when last used with a transducer, if no
transducer is connected.
IMPORTANT: A transducer must be connected to the 405SX in
order to retain user settings selected when in simulator mode. If
no transducer is detected, the unit defaults to pre-selected
options when powered off.
What You See On-Screen
Your 405SX uses a 160 x 160 matrix FSTN LCD display. This display provides
outstanding viewability in all light conditions over a wide range of
temperatures.
At initial power-up, the 405SX uses settings that were set at the factory. After
initial use, the 405SX will remember the settings you enter.
There are several elements on-screen that are common to all modes of operation.