4
If you are using the Pro Craft unit in Simulator when no transducer is con-
nected, any selected options are lost when the unit is powered off. The Pro
Craft unit will return to Factory Settings, or options selected when last used
with a transducer, if no transducer is connected.
IMPORTANT: A transducer must be connected to the Pro Craft unit
in order to retain user settings selected when in simulator mode.
If no transducer is detected, the unit defaults to pre-selected
options when powered off.
What You See On-Screen
Your Pro Craft unit uses a 128 V x 64 H
matrix FSTN LCD display. This display
provides outstanding viewability in all
light conditions over a wide range of
temperatures.
At initial power-up, the Pro Craft unit
uses settings that were set at the facto-
ry. After initial use, the Pro Craft unit will
remember the settings you enter.
There are several elements on-screen
that are common to all modes of opera-
tion.
Temperature/Speed.
The initial screen layout takes one of two basic forms
depending on whether the optional Temp/Speed accessory is installed. Figure
A shows the default view when the Temp/Speed accessory is installed. Figure B
shows the default view when the Temp/Speed accessory is not installed.
Depth.
The digital depth number shows the water depth directly beneath the
transducer location.
Depth Range.
The depth range is shown to the right of the screen. The upper
number is 0 indicating the surface of the water. The lower number is one of
the nine depth ranges available that best match the depth of the water. As the
USING THE PRO CRAFT UNIT
WHAT YOU SEE ON-SCREEN
Figure A
