Stem Mount
(Existing Stem with 1" - 14 Thread)
Follow these steps to stem mount the WSL antenna (stem not included):
1. Determine the best mounting location, then make sure that there is sufficient cable to route to
the Fishfinder. Mark the mounting location, then drill a
⁵₈
" (15 mm) hole.
2. Place stem over
⁵₈
" (15 mm) hole and mount with screws provided with stem.
3. Place lock nut on stem, thread down at least half way.
4. Route the WSL cable through the stem, then continue routing it through the deck surface to the control head.
5. Thread the WSL onto the stem. Tighten lock nut with crescent wrench to secure the WSL antenna.
Under Location Access with Thin Deck
(Less Than
³₈
" or 10 mm)
Follow these steps to mount the WSL antenna onto a deck that is thinner than
³₈
" (10 mm), routing the
cable down through the mounting surface:
1. Determine the best mounting location, then make sure there is sufficient cable to route to the
Fishfinder.
2. Mark mounting location and drill a 1" (25 mm) hole.
3. Insert mounting bolt through 1" (25 mm) hole from lower side of the mounting surface.
4. Place the gasket over the mounting bolt, then route the WSL cable down through the mounting bolt to the control head.
5. Position the WSL over the mounting bolt, then secure in place.
Under Location Access with Thick Deck
(More Than
³₈
" or 10 mm)
Follow these steps to mount the WSL antenna onto a deck that is thicker than
³₈
" (10 mm), routing the
cable down through the mounting surface:
1. Determine the best mounting location, then make sure that there is sufficient cable to route to
the fishfinder.
2. Place the mounting flange over your mounting location and mark the following locations for drill
holes: through the center of the mounting flange for the WSL cable, and through the
three mounting holes for the mounting flange.
3. Remove the mounting flange and drill a
⁵₈
" (15 mm) hole at the center location and drill the three
⁹₆₄
" (3.5 mm) mounting holes.
4. Assemble the mounting flange, mounting bolt, and gasket, then place over the
⁵₈
" (15 mm) center hole. Secure in
place with three #8 x
⁵₈
" flat head screws.
5. Position the WSL over the center hole and route the cable through the center hole, then secure in place.
6. Route the WSL cable to the control head.
WSL
Antenna
Gasket
Mounting
Flange
Mounting
Bolt
WSL
Antenna
Mounting
Bolt
Gasket
WSL
Antenna
Lock Nut
