To scan stations, press and hold the SEEK up
or down arrow for two seconds until you hear
a beep. The radio will go to a station, play for
a few seconds, then go on to the next station.
Press either SEEK arrow again to stop scanning.
To scan preset stations, press and hold the SEEK
up or down arrow for more than four seconds.
You will hear two beeps and PSCAN will appear
on the display, along with the highlighted preset.
The radio will go to the next preset station, play
for a few seconds, then go on to the next preset
station. Press either SEEK arrow again to stop
scanning presets.
The radio will only seek and scan stations with
a strong signal that are in the selected band.
Setting Preset Stations
Up to 30 stations, six AM, six FM1, six FM2,
six XM1, and six XM2, if equipped, can be
programmed using the six screen buttons on the
bottom of each band menu. To set preset stations,
do the following:
1. Turn the audio system on.
2. Press the BAND hard key to select AM, FM1,
FM2, XM1, or XM2, if equipped.
3. Tune in the desired station using the SEEK
hard key or the tuning knob.
4. Press and hold one of the six preset screen
buttons until you hear a beep. Whenever that
screen button is pressed, the station that
was set will return.
5. Repeat the steps for each preset and source.
59
