17
Set Standards
To set the Standards the HM-2750 will use, press
until you see this
screen:
Press
(SET DATE/TIME/UNITS/STND). You should see this screen:
Press
(STANDARD) to toggle between ASTM and BRITISH
STANDARD.
Select the standard desired—the flashing standard is the active choice.
To return to any prior screen you can always press
* REVIEW LAST TEST
* RUN TEST
* ENGINEERING SETUP
* SET DATE/TIME/UNITS/STND
* SET DATE
* SET TIME
* UNITS = ENG/METRIC
* STANDARD = ASTM/BS
Rate (Motor Speed Adjust)
To set the speed of the HM-2750 press
SPEED
You should see this
screen:
Press
(SPEED) to move between the numbers. Keep pressing
until the digit you want to change is flashing. Once you have
selected the number you want to change, press
(INCREASE) or
(DECREASE) to change the number to the desired value. Once
you have set the speed, press the
or
to activate it.
MOTOR SPEED ADJUST
* SPEED = “X.XXXX”
* INCREASE
* DECREASE
