Desk Mount
Installation Instructions
GT-NPD-IM-826-001
© 2019 Humanscale Corporation. The text and artwork are copyrighted materials.
All rights reserved. The Humanscale mark and logo are trademarks of Humanscale Corporation
and are registered in the United States and certain other countries. The M10 trademark is
owned by Humanscale Corporation.
M10 INSTALLATION HARDWARE
4mm Hex Key
3 Crossbar Link Screws
4 Plastic Spacers
4 Standard VESA Bracket Screws
4 Extended VESA Bracket Screws
5mm Hex Key
VESA Bracket and Cover
NOTE:
4mm and 5mm Hex Key can be
found under the plastic base cover.
8mm Hex Key
Bolt-Through Plate
Bolt-Through Bolts
Bolt-Through Mount
Crossbar Installation Hardware
Clamp Mount
Sliding Desk Mount
For our terms and conditions please go to
https://www.humanscale.com/about/legal-information/terms-conditions.cfm
STEP 9: CABLE MANAGEMENT
1. If using multiple monitors, first route the cables through the plastic cable clips on
the front of the crossbar. If using a single monitor, skip to step 2.
6. Slide the cover down the arm to lock in
place, then gently pull the cables
through the arm to remove excess slack.
5. Lift the cover and cables up to the lower
link, making sure that the cover sits
flush with the surface of the arm.
4. Using the two cutouts (D) as guides, run
the cables over the lower link cover.
3. Slide the plastic cover (C) on the lower
link upward to remove.
2. Route power and monitor cables
through the flexible cable clips on the
M8.1’s upper link (B).
NOTE:
Leave enough slack in the cables
to allow arms to rotate without difficulty.
CAUTION:
Don’t insert extension cords.
Don’t insert any cord connecting one
workstation to another.
B
C
D
A
STEP 8: WEIGHT ADJUSTMENT
A
C
E
D
Your monitor should move up and down easily and stay in place once adjusted. If it is
difficult to adjust or moves without assistance, it is not properly counterbalanced.
M10 Arm - Total Weight Range: 20-48 lbs. (9-21.7 kg)
Single Monitor - Max weight: 48 lbs. (21.7 kg)
Dual Crossbar - Max weight per monitor: 22.5 lbs. (10.2 kg)
Triple Crossbar - Max weight per monitor: 10 lbs. (4.5 kg)
1. To access the Adjustment Screw (E), use your finger to pry open the Cover (D) on
the Upper Arm Link (C).
2. Using the 5mm Hex Key turn the Adjustment Screw (S) clockwise to INCREASE the
load tension, and counter-clockwise to DECREASE the load tension. Turn the
Adjustment Screw (E) until the Monitor is properly balanced.
3. Move the monitor around to ensure that the motion is smooth and the arm functions
as intended and holds the monitor in place.
5. Reposition the Cover (D) and press until it snaps into place.
CAUTION:
Do not overtighten the screws as it can damage the screw head or threads.
