Place two spacers over the back leg screw hole, align the long hole on the mounting bracket
with the spacer hole, then secure the spacers and bracket using one of the short bolts (Fig.3).
Hand-tighten the bolt, leaving it slightly loose.
Place one spacer over the front leg screw hole, align the round hole on the mounting bracket
with the spacer hole, then secure the spacer and bracket using one of the long bolts (Fig.3).
Use a provided Allen wrench to tighten both the front and rear bolts.
Repeat steps 1 - 4 to install the mounting bracket on the opposite side of the second chair.
3
4
5
2 spacers
Short bolt
spacer
Long bolt
Mounting
bracket
Mounting
bracket
(Fig.3)
Back leg screw hole
Front leg screw hole
INSTALL THE MOUNTING BRACKETS
INSTALL THE TABLE ONTO THE MOUNTING BRACKETS
NOTE: If you are unable to insert the bolt, the barrel nut installed in the cross
bar is not properly aligned. Use your fingernail or a flat-head screwdriver to
turn the nut so that the notch runs parallel to the chair leg, then hold the
barrel nut in place while tightening the bolt.
Remove the table from the packaging, then carefully
place it face-down on a soft surface.
Install and hand-tighten the four mounting screw pins
as shown in Fig. 6.
Grasp the table with screw pins installed then lower the
table between the chair arms, aligning the mounting screw
pins with the corresponding holes in the mounting brackets.
Press down firmly to secure the table into the mounting
brackets (Fig.7). You may need to adjust the chair position
to align all four pins.
7
8
Fig. 6
Fig. 7
Position both chairs in the desired location. Do one of the following:
6
OR
Use a ruler to space the chairs as
shown in Fig. 5.
16.5”
6.5”
Fig. 5
Insert the alignment wires into the bracket
holes, pulling the chairs apart so the wires are
tight, as shown in Fig. 4. Remove the wires
after positioning; retain them for future use.
Fig. 4
Wire
Mounting screw pin
Mounting bracket
NOTE: If there are rubber grommets installed
in the mounting brackets, they may pop out
while installing the table. Replace them before
completing the installation.
Short bolt goes
through the
long
hole
Long bolt goes
through the
round
hole
Put wire solution before measure solution.