Human Touch iJoy Ottoman 3.5, Use & Care Manual

Page: 7 / 12

1.
Get acquainted...
3.
6
Master Switch
Before you get started, place the iJoy
Ottoman 3.5 in front of your favorite chair,
plug the iJoy Ottoman 3.5 into a 110 volt
wall outlet and fl ip the master power switch
to the “on” position. The blue power light
will illuminate on the dock console.
Massage Function Control
Remove the wireless remote control from
the dock console. Press the select button to
toggle through a selection of standard speed
and Auto Program Massage functions.
NOTICE
Prior to fi rst use:
Release iJoy Ottoman 3.5
wireless controller from
its socket and install a
single Button Cell CR 2032
Battery (included) in battery
compartment located on
back side of controller.
iJoy Ottoman 3.5 will not
function until battery is
properly installed in controller.
Massage Select Button
Press this button repeatedly to
toggle through each of three
fi xed speeds and two automatic
programs. The LED display on
the console dock will keep you
informed of your selection.
On-board Console Dock with Wireless Remote
Conveniently located, the Console Dock stores a full
function wireless remote control. You can control the
massage while the remote is docked or remove the
palm sized unit and sit back with full control over three
massge speeds and two automatic programs.
Stop Button
The Stop Button will
immediately cancel any
cycle or function that the
iJoy Ottoman 3.5 was set
at, and stop all motion.
Take full control
Finger Release /
iR Lens
Finger notch allows
you to remove the
docked remote for
hand held wireless
convenience. This
notch also receives
the wireless signals
broadcast by the
remote.
Speed
Press “select” button to
start massage speed
one. Repeated pressing
of “select” button will
select speed two and three.
Auto Programs
Repeated pressing of
“select” button will progess
massage function from fi xed
speeds to each of two
automatic massage programs.