Step 1 Arm Assembly
Be sure the mount is securely fastened to the surface before beginning.
Insert the pole of the arm assembly into the
mount. (Mounts will vary).
Use the 3/32” allen wrench, to tighten the set
screw on the mount. (Tighten enough so the
pole does not spin or slip through the mount).
Align the tilter and VESA bracket with the hole
pattern on the back of the flat panel monitor.
Use the four (4) M4-12 Philips Pan Head screws to
attach the plate to the back of the LCD monitor.
After securing the plate to the flat
panel insert the tilter into the arm.
Use the 10-32 x 3/8” Philips Flat Head
screw and washer and fasten them to
the hole in the underside of the tilter shaft,
locking the monitor in place.
Tilt the monitor so it faces upward and
locate the set screw under the tilter. Insert
the 7/32” Allen wrench into set screw to
adjust the tilt friction.
* To tighten friction turn the wrench to the right.
* To loosen, turn the wrench to the left.
Step 1A Arm Height Adjustment
To adjust the position of the extension(s), loosen the
set screw on the back of the of the extension(s)
then loosen the thumbscrew attached to the collar
under the arm.
The extension(s) and collar(s) will easily slide up
and down the pole. Tighten the thumbscrew on
the collar and the set screw on the back of
the extension(s) to lock into place at the
desired
height.
Step 2
Attach Tilter/VESA bracket to the monitor
Step 3
VESA Bracket Assembly Continued
Set
Screw
Step 4 Monitor to Arm Assembly
Step 5 Tilt Mechanism Adjustments
Carefully remove the base from the flat
panel monitor. (See your monitor’s User’s
Guide for instructions on how to do this.)
Attach the adapter plate (75MM or 100MM)
to the tilter mechanism, using four (4) #10-32
x 3/8” Flat Head Philips screws.
