![background image](http://html1.mh-extra.com/html/human-care/heliq/heliq_service-manual_2182734026.webp)
26
26
www.humancaregroup.com
Changing the hand control - Roomer S
ENG
1. Follow the steps 1-6 in the “opening the lift
chapter”.
2. Remove the connector on the hand control
cable from the circuit board (PCB) by
pressing on the small plastic lock on the top.
3. Remove the rubber seal from the cover.
4. Use for example a screwdriver to flip over
the cable to the left side like in pictures
below.
5. Pull the cable and the connector out through
the hole. If the hand control is damaged, you
can cut the cable and it will be easier to pull
out.
6. Repeat the steps in reverse in order to
connect the new hand control.