Hughes HX100, Installation Manual

Page: 56 / 138

Chapter 4 • Commissioning the HX50/HX100 Remote Terminal
38
1037106-0001 Revision B.03-Draft
Manual commissioning
If there is no satellite communication available to the installation
site (for example, if you cannot connect to the registration
server), you cannot use SBC and must therefore commission the
remote terminal manually. However, do not use the manual
commissioning method unless you are instructed to do so by the
service provider. Manual commissioning of the HX50/HX100
remote terminal consists of the following tasks:
•
Entering manual commissioning parameters
•
Antenna pointing
Entering manual
commissioning parameters
Follow these steps to enter the manual commissioning
parameters:
1. Open a web browser on the installer laptop.
2. Type
http://192.168.0.1/fs/registration/
setup.html
in the browser’s address or location bar and
press E
NTER
to access the Setup screen shown in Figure 17
on page 28. If an alternate IP address was assigned to the
remote terminal at the HX GTWY, use that IP address
instead.
3. Click Manual Commissioning . The Manual Commissioning
page appears as shown in Figure 28. Enter or select the
appropriate satellite, VSAT (remote terminal), LAN, and
management parameters. These parameters may be provided
to you in an installation specification, work order, or in
another form of communication from your installation
point-of-contact.
4. Click Save Configuration . The remote terminal saves the
parameters and reboots itself.
Note: The remote terminal’s serial number must be loaded
at the HX GTWY by an HX system operator in order to
complete the manual commissioning process.