Hughes HN9500, Installation Manual

Page: 102 / 136

Figure 53: Examples of state codes
Table 18: State codes on page 88 lists and explains all HN9500 state codes. In this table, router
refers to the satellite router .
Table 18: State codes
Corrective action Explanation State name State code
Installation – Boot phase
Transient – No action is necessary. Satellite router is starting up in boot
phase. Starting Up in Boot
1
Transient – No action is necessary. Router has not been installed, and
installation parameters have not
been submitted. Waiting for Installation
Parameters 2
Transient – No action is necessary. Antenna pointing is in progress
(coarse or fine pointing).
Occurs
during router installation only.
Coarse Pointing in
Progress 3
Transient – No action is necessary. Occurs during Auto router
replacement only:
Router is
searching for beacon.
Acquiring Beacon in
Boot 4
Transient – No action is necessary. Occurs during Auto router
replacement only:
Router is
searching for point-to-point signal.
Acquiring PTP SNR in
Boot 5
Installer should switch polarization. Router is waiting for installer to
switch uplink polarization at the Waiting for Uplink
Polarization Change 6
HN9500 Satellite Router Installation Guide
88
1037736-0001 Revision G
System Control Center Chapter 9