Hughes HN9400, Installation Manual

Page: 22 / 134

If there is any reason to remove power from the satellite
router, always unplug the AC power cord from the power source (power outlet, power strip, or
surge protector). Do
not remove the DC power cord from the router’s rear panel. Doing so could
result in an electrical shock or damage the router.
When you re-apply power to the router, plug the AC power cord into the power source.
Table 2: Power supply specifications for the HN9400 satellite router
Electrical requirements Part number Power supply type
Input line voltage: 1500089-0001 AC/DC (64 W)
90 to 264 VAC, 2 A maximum
Input line frequency:
50 to 60 Hz AC
Rated power consumption: 64 W
Input line voltage: 1500185-0001 AC/DC (80 W)
90 to 264 VAC, 2 A maximum
Input line frequency:
50 to 60 Hz AC
Rated power consumption: 80 W
Input line voltage:
12 to 24 VDC, 10 A maximum
1033554-0001 DC/DC (65 W)
Rated power consumption: 65 W
All listed power supplies may be used with a 1 W or 2 W Ka-band or Ku-band radio. All have a detachable
power cord.
Computer and networking requirements
This section lists the requirements for the computer or other device, network, and browser to be
used with the satellite router.
Computer requirements
The HN9400 satellite router can be used with any device that supports IP and has a 10/100 BaseT
Ethernet LAN port. Typically, the router is connected to a customer's computer. However, the
HN9400 is self-hosted; it does not require a computer for any of its functions.
Requirements for the computer to be used with the satellite router are the same for the laptop
computer you use to install the router and the customer’s computer that will be connected to the
router. In either case, the computer should meet the minimum requirements specified by the
computer operating system manufacturer and the following networking and browser requirements.
HN9400 Satellite Router Installation Guide
10
1038554-0001 Revision B
Preparing for installation Chapter 2