Options
The following options can be used to modify the currently
chosen cycle, signal volume and control lock.
Soak
The Soak option is added to the beginning of the cycle. Use for
heavily soiled or stained clothing. The washtub will fill with wa-
ter, agitate for a reduced period of time, and pause for the set
amount of time.
The Soak LED will flash to indicate that you can set the
amount of soak time by pressing the Soak keypad again or the
up and down arrow keypads. The time will increase by 15 mi-
nutes up to an hour and then go up by one hour increments.
The maximum soak time is 24 hours.
The soak LED also will flash during any soak portion of the cy-
cle.
Pre-Wash
The Pre-Wash option adds an additional eight-minute wash be-
fore the selected cycle. At the end of the pre-wash, the dirty
wash water will drain from the tub and the machine will sound
a three-second tone to indicate that pre-wash has completed.
The lid will unlock so any additional laundry supplies may be
added.
Push the start button to resume the selected cycle. If there is
no activity for two minutes, the cycle will resume automatically
and the machine will refill with water and continue with the se-
lected cycle.
Extra Rinse
This Option will provide an additional rinse to the selected cy-
cle. With the Warm/Warm temperature selection this rinse will
use warm water. All other temperature selections use cold wa-
ter.
Speed Cycle
Selecting the Speed Cycle Option will shorten the wash agitate
and final spin times by 30%.
Delay Start
Pressing the Delay Start Option will allow the cycle to begin up
to 24 hours later. Pressing it once will delay the cycle by one
hour and
1h
will display on the control. Press the Delay Start
keypad again or the up arrow keypad. The time will increase by
one hour. Press the Start/Pause keypad to begin the count-
down.
While setting the Delay Start Option, the cycle time and the
Delay Start keypad light will flash (1 second on/off).
After the Delay Start Option is started, the Delay Start keypad
light will flash (1 second on/off).
Signal
Pressing the Signal keypad will change the end of cycle signal
volume. There are four settings: Off, Low, Medium, High.
Control Lock (Secure keypad)
Pressing and holding the Signal keypad for three seconds will
turn on the Control Lock. The Control Lock status light will be
lit. While Control Lock is on, no other keypad presses are al-
lowed. Press and hold the Signal keypad again to turn the op-
tion off.
Status
The active Status light will flash at the beginning of the cycle.
The Status lights are lit throughout the cycle to show what part
of the cycle is running.
Light
Description
Wash
The Wash status light is lit during the
first fill step and the wash step of the cy-
cle including Pre-Wash and Soak, if se-
lected.
Rinse
The Rinse status light is lit during the
rinse portions of the cycle including Ex-
tra Rinse, if selected.
Spin
The Spin status light is lit during the final
spin portion of the cycle.
Lid Lock
The Lid Lock status light will flash when
trying to lock. It is lit any time the lid is
locked.
Table 4
Control Panel
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
14
Part No. 204949EN
Summary of Contents for Alliance Laundry Systems TR7
Page 2: ......
