Hud-son BADGER FIREWOOD PROCESSOR, Operator'S Manual, Page: 28 / 32

28
Firewood Processor Warranty
HYD-02-08-16 Flow Control Valve
CHA-01-375-050-87 Saw Chain
SPR-01-12-26 Sprocket
KEY-01-03-24 Chain sprocket key - 1/4 - key way
SAW-01-25 Saw Bar Stihl Patterns 3623-005-
BEA-01-12 Bearing 3/4 drive assy.
BEL-02-58-063 Belt
CLU-02-18 Clutch (Ogura)
COU-03-L100-18 Love joy pump -L100 5/8
COU-06-L100-16 Spyder
PUM-002 Oil pump (BAR)
TAN-01-6Q 6qt.Processor Lube Tank w/o Pump
SS808-81-0004 Soft Start
BAT-02-230 Battery
FIL-02-10-20 Filters ( hyd. filter)
2017 and newer filter (hyd.) Hud-Son #HY-FL-17-20; Common# U9L3FE
HYD-03-25-12-08 Splitter Valve
CHA-05-04-68 Choker chain
CAB-02-04 Cable throttle cable
TRA-02-015 Jack
ENG-05-010 Tach and Hour
1) Introduction To Your Warranty
Warranty registration cards must be completed
and returned to Hud-Son Forest Equipment,
Inc within 30 days of purchase. Failure to do
so will void the warranty!
Warranty claims must be registered with the
Dealer/Distributor, and defective parts must be
returned to the Dealer/Distributor at the
owner's expense. The Dealer/Distributor will
assume cost of shipping one way in regards to
any warranty claim. Freight is standard UPS
ground. Any expedited services are at an addi-
tional charge and will be paid in full before
shipping at the owner’s expense.
All processors have a 90-day warranty against
manufacturers defects.
2) What's Covered And By Who?
Out sourced components will be warranted by
the respective company for a period equal to
the warranty in place at the time of shipping,
as shown below from date of purchase.
If a 6-way wedge is purchased, the splitting
system/hydraulic cylinder & weldment/fixtures
warranty could be voided.
Due to operator mis-use, and or neglect of the
operator to use good judgement when using the
6 way wedge. For example: the operator tries
to cross cut a block of wood or split a block
that has extreme cross grain or has knots that
will cause the splitter to jam or cause personal
injury or damage to the machine.
This will be determined after the inspection of
the Manufactory of Hud-Son,and the compo-
nent MFG of the hydraulic system compo-
nents, causes of damage from these items
could raise from. Operator tampering with
pressure controls or relief valves that are facto-
ry set, and can be checked to see if they have
been tampered with or reset from a factory set-
ting.
DESCRIPTION
PART NUMBER