SFBTT15 BOBTAIL® Hydraulic Tool
(HK1151)
Alcoa Fastening Systems
6
3.74
(9.5)
3.27
(8.3)
.47
(1.2)
2.16
(5.5)
2.63
(6.7)
The nose assembly is placed over the end of the fastener
until the tool's puller bottoms on the fastener. When the
trigger is pressed, a solenoid‐operated valve in the powerig
directs pressurized hydraulic fluid through the PULL hose to
the rear side of the piston and allows fluid on the RETURN
side to flow back to the tank. The piston moves forward to
start the swaging process.
After the fastener is fully swaged, the trigger must be
released, at which point the solenoid is de‐energized and the
valve directs pressurized hydraulic fluid to the front side of
the piston and allows fluid on the PULL side to flow back to
the tank. This causes the piston to move back while pushing
the anvil off of the swaged collar, releasing the tool from the
fastener.
P
P
RINCIPLE
RINCIPLE
OF
OF
O
O
PERATION
PERATION
S
S
PECIFICATIONS
PECIFICATIONS
Power Source:
Huck POWERIG Hydraulic Unit
Hose Kits:
Use only genuine HUCK Hose Kits rated @
10,000 psi working pressure.
Hydraulic Fluid:
Hydraulic fluid shall meet DEXRON III,
DEXRON VI, MERCON, Allison C‐4 or equivalent ATF
specifications. Fire resistant fluid may be used if it is an
ester based fluid such as Quintolubric HFD or equivalent.
Water based fluid shall NOT be used as serious damage
to equipment will occur.
Max Operating Temp:
125 ° F (
51.7 ° C
)
Max Flow Rate:
2 gpm (
7.6 l/m
)
Max Inlet Pull Pressure:
6,000 psi, (
414 bar
)
Max Inlet Return Pressure:
5,000 psi, (
345 bar
)
Pull Capacity:
13,960 lbf (
62 KN
)
Return Capacity:
8,940 lbf (
40 KN
)
Stroke:
1.450 inches (
3.7 cm
)
Weight:
6.0 lbs (
2.72 kg
)
Inches
(cm)
F
IGURE
2
RETURN
PULL
Piston
Piston
SECTION A-A
SECTION B-B
A
B
A
B
F
IGURE
1