Hubner Cobolt 06-01 Series, Owner'S Manual

Page: 46 / 60

46 | 60
OWNERS MANUAL | Cobolt 08-01 Series | D0141-K SEPTEMBER 2020
Communication commands
The laser is delivered in Auto-start mode (see section 3 for Auto-start sequence description). For system integration
the Auto-start sequence can be disabled, and the following commands can be used to control the laser. If power is
supplied to the laser the temperature control elements are always operating to reach set-point values and the laser
will be idle waiting for the next command. All arguments are in lower case and separated by a space (ASCII 32).
NOTICE Some commands require Auto-start to be disabled but others will work when Auto-start is
active.
Command Function Argument Returned value
l? Get laser ON/OFF state
0
= OFF
1 = ON
@cob1 Laser ON – Force autostart
If autostart is enabled the autostart sequence
will ‘Restart’. If autostart is disabled, the laser
will go through a forced autostart sequence.
@cob
0
Laser OFF
If ‘Autostart’ is enabled the start -up sequence
will ‘Abort’. If ‘Autostart’ is disabled all laser will
go directly into an OFF state.
@cobasdr1 Enable 5V direct input (OEM only)
@cobasdr
0
Disable 5V direct input (OEM only)
l1 Laser ON.
If ‘Autostart’ is enabled the start -up sequence
will ‘Restart’. If ‘Autostart’ is disabled all laser
will go directly into an ON state.
l
0
Laser OFF
@cobasks Get key switch state
0
= Key in OFF position
1 = Key in ON position
cp Enter constant power mode
p? Get output power set point Float (W)
p Set output power Float (W)
pa? Read actual output power Float (W)
ci Enter constant current mode
slc Set laser current Float (mA)
glc? Get laser current set point Float (mA)
rlc Read actual laser current Float (mA)
em Enter modulation mode
games? Get analog modulation enable state *
0
= disabled
1 = enabled