10 | 60
OWNERS MANUAL | Cobolt 08-01 Series | D0141-K SEPTEMBER 2020
Quick Start Guide
06-MLD
1.
Mount the laser on a heat sink or suitable flat surface that provides adequate heat dissipation and connection
to ground
. Use the four holes on the laser’s base plate to secure it.
2.
Attach the 15-pin D-SUB cable to the laser head.
3.
Attach the 15-pin D-SUB cable to the Control Box.
4.
Insert the interlock plug into the connector on the laser head.
5.
Connect the supplied 5V power supply unit to the socket on the laser head and plug it in to the mains.
6.
To start the laser, turn the key on the Control Box clockwise to the ON position. If it is already in the ON
position, turn it to OFF and then ON again. Light will be emitted as soon as the key is turned.
