6
LENS WIRE GUARD INSTALLATION (If Optioned):
1. With the screws removed, spread the guard apart slightly and fit it around the lens ring already attached to the reflector.
2. The guard should mount around the lens ring such that the ring fits between the top two circular rings.
3. Insert the screws (2x) through the mounting holes and thread on the hexagonal kepis nuts (2x). Tighten the nuts till the
guard is clamped around the lens ring.
INSTALLATION INSTRUCTIONS
UTB2
INSTALLATION INSTRUCTIONS
Hubbell Lighting, Inc. Doc. No. 93097040
A subsidiary of Hubbell Incorporated Revision P0
701 Millennium Drive • Greenville, SC 29607 Page 6 Phone (864) 678-1000
OPTICS WIRE GUARD INSTALLATION (If Optioned):
1.
With mounting screws removed from heatsink, install full wire guard (WG‐16) onto Reflector.
2.
Install Reflector onto fixture heatsink using screws (4x) provided.
LENS WIRE GUARD INSTALLATION (If Optioned):
1.
With the screws removed, spread the guard apart slightly and fit it around the lens ring already attached to the reflector.
2.
The guard should mount around the lens ring such that the ring fits between the top two circular rings.
3.
Insert the screws (2x) through the mounting holes and thread on the hexagonal kepis nuts (2x). Tighten the nuts till the
guard is clamped around the lens ring.
FIGURE 6A
FULL WIRE GUARD ASSEMBLY WG-16
FIGURE 6B
FULL WIRE GUARD ASSEMBLY
w/DEEP LENS GUARD (WG-16D)
FIGURE 6B
FULL WIRE GUARD ASSEMBLY
w/SHALLOW LENS GUARD (WG-16S)
A
DETAIL A
BOTTOM VIEW OF WG-16
EACH MOUNTING SCREW
FASTENS THRU OPTIC
INTO WG-16 CLIPS TO
INSTALL INTO HEATSINK
THREADED HOLES (4x)
FOR P95 &
NO LENS
OPTIONS
FOR DLR &
CDL LENS
OPTIONS
