LAREDO LMC LED INSTALLATION INSTRUCTIONS (PG 2/2)
SAVE THESE INSTRUCTIONS
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
www.hubbelloutdoor.com
STEP III FIXTURE MOUNTING (See Fig. 3)
• Hold fixture at a slight angle, slide over mounting plate and
rotate downward to capture plate.
• Tighten screw (G) securely.
• Check to ensure secure mount.
⊕
For –BOC equipped product, open the door frame
by loosening door frame closure screws and allow
the door to swing open. Locate RED and WHITE
leads for inverter connector located at front fixture.
Connect red and white wires located inside door.
⊕
Close door frame by swinging back into position
ensuring wires are not pinched under door mounted
reflector. Tighten door frame screws until snug.
• Energize product.
Step II WIRING (See Fig. 2)
POWER MUST BE OFF.
(WIRING MUST BE PERFORMED BY A QUALIFIED
ELECTRICIAN)
CAUTION! SHOCK HAZARD, DO NOT CONNECT RED AND
WHITE WIRES TOGETHER UNTIL ALL OTHER
CONNECTIONS HAVE BEEN MADE.
• Wire service leads to fixture power leads according to local
and National Electric Codes.
• Luminaire is equipped with a universal voltage driver capable of
120V-277V input.
• For direct wire connections, connect ground wire to green
wire. Connect black to black and white to neutral then push
connections back inside J-box.
⊕
For –BOC equipped product, make connections to
product per the supplemental Battery Backup Installation
Instructions included with the fixture.
A
B
FIG. 2
FIG. 3
G
NOTE: DO NOT OPEN THIS PRODUCT UNLESS INSTRUCTED BY STEPS INCLUDED IN
THESE INSTRUCTIONS OR BY HUBBELL LIGHTING TECHNICAL SUPPORT PERSONNEL.
FIXTURE HAS BEEN DESIGNED WITH EASY TO INSTALL MOUNTING BRACKETS.
93029166 Rev C - Page 2 of 2
