VoIP Telephone.
5
3.
Quick Start Guide
Full programming and configuration details are contained in the Configuration
guide, available from
www.hubbell.com/gai-tronics/en/voip-support
The factory defaults will generally be sufficient in most cases, but the following
steps must be taken as a minimum:
•
Provide an Ethernet connection and power (either 24-48Vdc or PoE)
•
Ensure that a DHCP server is available on the network, and that the IP
address allocated to the telephone can be discovered (DHCP is the normal
factory default provisioning method). If DHCP fails (or there is no DHCP
server) the telephone will revert to a default IP address of 192.168.1.2
after a few minutes
•
Using a web browser, browse to the IP address.
•
When prompted, enter the user name and password (Defaults:
username
&
password
)
•
From the Home Page, select the Configuration section, and from that the
VoIP Accounts main page
•
On the VoIP Account 1 Information sub-page, enter:
o
The user name (the extension number or name used by the SIP
server for this telephone)
o
Domain name, Proxy domain name and Register domain name
–
set all of these to the domain name or IP address of the SIP
server
o
Auth user password
– set to the authentication password for the
extension on the SIP server if required.
o
Ensure Provider enable and Register enable are both set to
enable.
o
Update the changes, then save the changes.
o
Check that the registration state changes to “registered”
•
Program any speed dial memories using the User Configuration main page
