Hubbell Canada LP, Lighting Division
870 Brock Road South, Pickering, ON, L1W 1Z8
Tel. (905) 8391138
For more information, visit our website:
www.hubbellonline.com
INSTALLATION INSTRUCTIONS
NRG Wallpack
NRG300B Series
WARNING
DISCONNECT POWER DURING INSTALLATION AND BEFORE SERVICING.
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION
REPLACE FRONT HOUSING
Replace front housing by reversing procedure used to remove it.
BOTTOM CONDUIT HOLE
With front housing and reflector off, either frill or tap out recessed Indention
in bottom of rear housing. Pull service wires through. Bottom of conduit hole
and make connections under wiring reflector.
Replace reflector and front housing reversing procedures used to remove.
IMPORTANT
To weatherproof your outdoor installation, be sure to seal all holes in
BRASSWASHER HOLE fixture housing. (Mounting, conduit, plugs, photo controls,
etc) with silicone sealant.
TROUBLE SHOOTERCHECK LIST
If Light Does Not Work:
Check Your Power Source
Check If Lamp Burned Out.
Check Electrical Connections
Check To Insure Proper Seating of Lamp
