Tools Required
:
F
” Hex Key
5/32
” Hex Key
G
” Wrench
N
” Open End Wrench
Ratchet with
N
” Deep Socket
Revised 9/01/10 ECN 100901003 Status 11
Part No. 95449
Vandal Resistant Bollard
Installation Instructions
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861
WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code.
Failure to do so may result in serious personal injury.
MAINTENANCE: To maintain light efficiency and prevent fixture overheating, globe must be kept clean and free of
dirt, dust, leaves, and trash. Globe should be regularly cleaned with a solution of ammonia and water or a suitable
glass cleaner.
NOTE: All electrical work must be done by a qualified electrician. KEEP THIS SHEET FOR FUTURE REFERENCE.
VRB2 & VRB4
Dual Function
VRB1 & VRB3
Single Function
Top Cap
Stacked
Vertical
Louvers
Pole Body
!
Make certain the electrical supply is
OFF
before starting installation.
1. Install the base casting/ballast
assembly on the pre-set anchor
bolts. Use flat washers and hex
nuts both below and above the
base casting.
2. Level the top edge of the casting by
adjusting the bottom leveling nuts.
Tighten the upper nuts.
3. Tighten the upper nuts using a
N
"
deep socket.
4. Connect the circuit ground wire to
the green wire connected to the
grounding lug on the ballast
bracket. Connect power supply
leads to the ballast input leads,
green-to-ground, white-to-common
& black-to-voltage (see diagram).
BASE CASTING / BALLAST ASSEMBLY INSTALLATION INSTRUCTIONS:
NOTE:
For incandescent fixtures,
connect the power supply leads directly
to the lamp leads -
no ballast required.
Base/Ballast
Bracket Assembly
!
