EVHC Series
93051469
SERVICE /MAINTENANCE
4. Disconnect the battery strap and remove battery pack.
3. Disconnect the battery harness from the charger pcb.
Batteries are shipped uncharged, please charge for 24 hours before testing.
Make sure the switch pcb and the button/light pipe is correctly seated and aligned.
93049114 1 10/13
93051469
93051472
93050644
93051471
93051470
OPERATION
93052054
93051841
Dual-Lite
EVHC Series
93051469
SERVICE /MAINTENANCE
4. Disconnect the battery strap and remove battery pack.
3. Disconnect the battery harness from the charger pcb.
Batteries are shipped uncharged, please charge for 24 hours before testing.
Make sure the switch pcb and the button/light pipe is correctly seated and aligned.
93049114 1 10/13
93051469
93051472
93050644
93051471
93051470
OPERATION
93052054
93051841
Dual-Lite
WARNING
– This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or
otherwise touching this product.
Emergency Lighting Equipment For Use in Damp Locations
Damp location listed units are suitable for installation in:
1. Interior locations subject to moderate degrees of moisture, such as some basements, some barns,
some cold storage
warehouses, and the like.
2. Partially protected locations under canopies, marquees, roofed open porches and the like.
Twin-Head LED Emergency Lighting Unit
Standard, Remote, and Spectron
®
Equipped Models
Installation, Operation, and Service Instructions
EVHC Series
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
Do not use outdoors.
2.
Do not let power supply cords touch hot surfaces.
3.
Do not mount near gas or electric heaters.
4.
Equipment should be mounted in locations and at heights where it will not readily be subject
to tampering by unauthorized personnel.
5.
The use of accessory equipment not authorized by the manufacturer may cause an
unsafe condition.
6.
Do not use this equipment for other than its intended purpose.
7.
Servicing of this equipment should be performed by qualified service personnel.
8.
Test cycling: the Life Safety Code (NFPA 101) requires testing of emergency lighting units once a month for a
minimum of 30 seconds, and once a year for a minimum of 90 minutes.
INSTALLER:
•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
RECYCLING INFORMATION
All steel, aluminum and thermoplastic parts
are recyclable.
NOTICE: Emergency units contain rechargeable batteries which
must be recycled or disposed of properly.
Hubbell Lighting, Inc. Life Safety Products • www.dual-lite.com
Copyright
©
Hubbell Lighting, Inc., All Rights Reserved • Specifications subject to change without notice. • Printed in U.S.A.
93049114_F
5/15
Service / Maintenance
Installing the Unit: Final Assembly
1. Align housing slots over tabs on backplate.
2. Pivot housing and snap closed.
3. Aim the lamps. Do not press on the lenses.
SERVICE/MAINTENANCE
Maintenance
This emergency lighting unit should be tested and maintained in accordance with National Electrical Code and NFPA 101 Life Safety
Code requirements. It is recommended that emergency light fixtures be tested for 30 seconds once a month and for 90 minutes once a
year.
Taking A Unit Out Of Service
If a unit is to be deliberately taken out of service for an extended period, the battery lead connector should be disconnected from the
charger circuit board and insulated so that the battery will go into storage in a fully charged condition.
Replacing The Battery
1. De-energize the AC power.
2. Disengage the housing cover from the backplate.
3. Disconnect the battery leads from the charger circuit board.
4. Remove the battery from the clips inside the cover.
5. Replace with a new battery (see unit model label for correct part number) and reconnect leads.
6. Reassemble cover to backplate.
Replacing LED Lamps
The LED lamps inside the unit are not replaceable or field serviceable. Please see dual-lite.com for further assistance.
Troubleshooting
Emergency circuit does not work
• Batteries are shipped uncharged and disconnected. Connect battery leads and charge 24 hours before testing.
• Make sure the charger board and test button/light pipe are properly seated and aligned.
• Check wiring connections.
Hubbell Lighting, Inc. Life safety Products • www.dual-lite.com
Copyright© Hubbell Lighting, Inc., All rights reserved • Specifications subject to change without notice.
Printed in U.S.A.
93033106_A 2/11
RECYCLING INFORMATION
All steel, aluminum, and thermoplastic parts are recyclable.
NOTICE: Emergency units contain rechargeable batteries which
must be recycled or disposed of properly.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed, including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cord touch conductive surfaces.
3. Do not mount equipment near gas or electric heaters.
4. Equipment should be mounted in locations and at heights where it will not readily be subject
to tampering by unauthorized personnel.
5. The use of accessory equipment not authorized by the manufacturer may cause an unsafe
condition.
6. Do not use this equipment for other than its intended purpose.
7. Servicing of this equipment should be performed by qualified service personnel.
8. Test cycling: the Life Safety Code (NFPA 101) requires testing of emergency lighting units
once a month for a minimum of 30 seconds, and once a year for a minimum of 90 minutes.
INSTALLER:
SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
Twin-Head LED Emergency Lighting Unit
Standard, Remote, and Spectron® Equipped Models
Installation, Operation, and Service Instructions
WARNING – This product contains chemicals known to the state of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or
otherwise touching this product.
Emergency Lighting Equipment For Use In Damp Locations
Damp location listed units are suitable for installation in:
1. Interior locations subject to moderate degrees of moisture, such as some basements, some barns,
some cold storage warehouses, and the like.
2. Partially protected locations under canopies, marquees, roofed open porches and the like.
OPERATION
93051469
3. Disconnect the battery harness from the charger pcb.
4. Disconnect the battery strap and remove battery pack.
5. Replace with a new battery (see unit model label or battery label for correct part number) and reconnect harness.
• Batteries are shipped uncharged, please charge for 24 hours before testing.
• Make sure the switch pcb and the button/light pipe is correctly seated and aligned.
• Check wiring connections.
93051469
93051470
93051471
93051472
93052054
93054690
93055110
Testing Period
Duration of Test
Once a month
1 minute
Once every
Alternating:
6 months
30 minutes or 60 minutes
Initiating Action
Test Cycle
Press test switch once
1 minute
Press test switch twice
90 minutes
Dual-Lite.com for further assistance.
Automatic Tests
The unit will automatically initiate a self-test/self-diagnostic
cycle based on the following table:
Manual Tests
Using the unit test switch, users can initiate different
duration test cycles based on the following table:
Pressing the test switch any time after a 90 minute test
cycle has begun cancels the remainder of the 90 minute
test and returns the unit to normal operation.
