Assembly Instructions
C35
Mobius Floor Lamp 23-4505 & 23-4505C
Page 2 of 7
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont
24809 Rev C
Assemble
(Figure 4)
Component Parts
I
Upper Assembly
J
Base Assembly
K Coiled wire
1.
Slip upper assembly (I) into base assembly (J).
2.
Lower upper assembly (I) as far into the base assembly (J) so the coiled wire (K)
with the connector comes out into the wireway area in the base.
Complete Wiring in the Base
(Figures 5 & 6)
Component Parts
A 8-32 Screw (2)
B Wireway Cover Plate
F Hex Nut (2)
J
Base Assembly
K Coiled wire
L
Strain Relief
M Cover Plate
N Male Quick Connect
O Female Quick Connect
1.
Remove cover plate (M) by loosening and
removing two hex nuts (F) from base assembly (J).
Save for later use.
2.
Pull coiled wire (K) with male quick connect (N)
and two wire crimps from the center of the fixture
and push through the cover plate (M).
3.
Snap strain relief (L) into cover plate (M).
4.
Replace cover plate (M) and the two hex nuts (F).
Tighten hex nuts until snug.
5.
Plug the male quick connect (N) into the female
quick connect (O).
6.
Replace the wireway cover plate (M) and the two
8-32 screws (A)
(Figure 6, next page).
(continued)
(Figure 5)
(Figure 4)
Summary of Contents for Mobius 23-4505
Page 4: ......
