background image

40148

Assembly & Installation Instructions

B380

Edge Outdoor Sconces 302560 & 302563

MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING

CASTLETON, VERMONT USA | HUBBARDTONFORGE.COM

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased 
this product.  We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this 
fixture.

Page 4 of 4

To Install Fixture 

(Figures 3 & 4)

1.  Place the mounting bracket (B) over the electrical box 

being sure to hold it level. Line up holes in 
mounting bracket with holes in electrical box.  With a 
pencil, mark the location of all mounting holes in the 
mounting bracket on the wall behind. Set bracket aside.

2.  Drill 1/4" holes in the locations marked on the wall. 

Place the tapered end of the anchors (C) into the holes 
and gently tap them flush to the wall using a light 
weight hammer. 

3.  Thread the wires in the electrical box through the hole 

in the mounting bracket (B) while moving the plate into 
position. Using two machine screws (not provided) 
fasten the mounting bracket to the electric box. 

 

Note: 

A new electric box comes with screws. When 

replacing an existing fixture, retain screws for use with 

the new fixture.

4.  Using #10 screws (D), screw the mounting bracket (B) 

securely to the wall. Be careful not to over-tighten or 
strip the anchors (C). 

5.  Attach a pigtail lead to the mounting bracket (B) using 

the cupped washer (E) and ground screw (F) found in kit 
bag.  See location in Figure 3.

6.  Hold fixture (A) close to wall. Using suitable wire 

connectors (not provided), connect fixture wires to 
supply wires (white to white and black to black). 
Connect all ground wires (bare copper or green to bare 
copper or green). 
 
 

7.  Apply a generous bead of a suitable caulking material 

(not provided) to caulking lip (G) on the fixture. Caulk 

should be applied around the entire perimeter of the 

backplate (Figure 4).

8.  Place fixture (A) over mounting bracket (B) and screw 

with #8 screws (H) and rubber washers (I) on top and 

#8 screws on bottom.  Be sure no wires are pinched 

between fixture and the wall. 

9.  Restore electricity at main breaker. 

CAUTION:

 MAKE SURE WIRE CONNECTORS ARE 

TWISTED ON SECURELY, AND NO BARE WIRES ARE 

EXPOSED.

B

C

D

A

MACHINE 
SCREWS

E

I

F

H

(Figure 3)

(Figure 3)

G

A

G

G

G

(Figure 4)

Reviews: