6
parameters, clock modification, etc., press the selection key to cycle through the options
included in the above seven main menus select.
(1) When the cursor is in the current selection, press the selection key to select the current.
(2) When the cursor is on the phase tap, when the cursor is on the phase tap, press the
select key, and the phase can be selected from AB, BC, CA, AO, BO, CO, ab, bc, ca, ao,
bo, co Cycle display between. Press the start key to move the cursor to tap, press the
select key to change the number between 0-9 (ten's place), press the start key to move
the cursor to the ones place, press the select key to change the number between 0-9.
(3) When the cursor is at the winding temperature, press the start key to scroll the cursor
among the three data bits, and the select key can make the data of each data bit cyclically
display between 0-9.
(4) When the cursor is at the conversion temperature, press the select key, and the
conversion temperature can be displayed cyclically among 75
℃
, 85
℃
, 115
℃
, 125
℃
and
145
℃
.
(5) When the current option is any option except winding temperature, press the start key
to start the measurement.
2. After the current is selected, press the start button to start charging. After the LCD
displays "Charging" for a few seconds, it displays "Testing" at this time, indicating that the
charging is completed and the test state is entered. After a few seconds, the test result will
be displayed, as shown in Figure 3:
Figure 3
According to the prompt, press the select key for about two seconds to print the current
data, and press the cycle key for about two seconds to store the current data to the U disk.
3. Move the cursor to the data query menu in the boot interface, and then press the select
