Huawei V100R021C10, User Manual

Page: 79 / 287

3.10.3 Installing a PAD
Preparations
Tool: Phillips screwdriver
Materials: PAD mounting bracket, PAD
Procedure
Step 1 (Optional) If the feet in the lower part of the PAD mounting bracket are not as
wide as the PAD, adjust the feet, as shown in Figure 3-69 .
1. Loosen the M4x12 screws on the foot (do not remove it), as shown by (1) in
Figure 3-69 .
2. Adjust the foot symmetrically until it is as wide as the PAD, as shown by (2) in
Figure 3-69 .
3. Tighten the M4x12 screws on the foot, as shown by (3) in Figure 3-69 .
Figure 3-69 Adjusting the foot
Step 2 Remove the cable hole baffle plate from the PAD mounting kit, as shown by (1) in
Figure 3-70 .
Step 3 Remove the nut from the PAD mounting bracket and secure the bracket to the
PAD mounting kit using the nut, as shown by (2) in Figure 3-70 .
Step 4 Route the PAD power cable through the cable hole in the PAD mounting kit and
connect it to the PAD, as shown by (3) in Figure 3-70 .
Step 5 Adjust the foot in the upper part of the PAD mounting bracket and clamp the PAD
into the mounting bracket, as shown by (4) in Figure 3-70 .
FusionModule2000-S Smart Modular Data Center
User Manual 3 Hardware Installation
Issue 03 (2021-07-15) Copyright © Huawei Technologies Co., Ltd. 70