UPS5000-S-600 kVA
User Manual (Three-phase, Three-wire)
4 User Interface
Issue 05 (2019-12-20)
Copyright © Huawei Technologies Co., Ltd.
147
The NTP parameters are used to set the NTP server address, port number, and
synchronization interval.
The default SNMP version is SNMPv3, and the preset MD5/SHA password is
Changeme1
, and the preset DES/AES password is
Changeme2
. Change the password
after your first login, preventing unauthorized access.
The standard protocols SNMP V1 and SNMP V2 have security risks. You are advised to use the
secure protocol SNMP V3.
The standard encryption algorithms MD5 and DES have security risks. You are advised to use the
secure encryption algorithms SHA and AES.
To obtain the MIB file, choose
Config.
>
Site Config.
>
SNMP
>
Download
HUAWEI_UPS_MIB
.
SNMP Trap
indicates the IP address of the server configured with network management
system (NMS) software. If
SNMP Trap
is incorrectly set or not set, system information
will be lost or not reported in time.
The certificate is used for Secure Sockets Layer (SSL) encryption protection for WebUI
login. You need to apply to a third-party institution for the certificate.
Configuration Management
is used to upload and export configuration parameters in
the monitoring system.
Multi-brand Management
is used to import the brand information of a partner to the
corresponding WebUI.
Specify
Email server IP address
,
Sender's email
, and
User account authentication
required
when sending a mail and click
Test
to check whether the test email can be
received.
Configure Alarm Notification Server
is used to configure a server for
receiving alarm emails from the monitoring system.
Set
and
Alarm Severity
and simulate an alarm. Check that the alarm email can be
received.
Configure Alarm Notification Email Address
is used to configure the email
address for receiving alarm emails from the monitoring system.
ModbusTCP Certificate Management
: ModbusTCP supports the Transport Layer
Security (TLS) secure protocol for encrypted transmission and implements access
authentication through the bidirectional certificate. Customers can replace the UPS
certificate with the certificate trusted by them.
ModbusTCP CA Certificate Management
: Import a CA certificate to verify the
validity of the ModbusTCP access certificate.
ModbusTCP Authentication
: Verify the identity legitimacy of both parties to ensure
data security for both parties in ModbusTCP communication.
After eUPS certificate management is configured, a certificate can be imported on the
WebUI to replace the preset eUPS certificate.
When using the mobile app for site setup or inspection, set WiFi SSID after connecting a
WiFi module over a USB port to identify the WiFi device to which the mobile phone is
connected.
4.2.4.3 RCCMD
RCCMD
RCCMD function
is set to
Disable
by default, as shown in
. If required, set it to
Enable
upon first login. After you submit the setting, the page refreshes. The controls such as
SSL Encrypted Transmission
and
Event Configuration
will be displayed on the page, as
shown in
