3
Connecting Equipment
4.2
Connecting to the Wall Outlet
4.3
Plug Computer into Master Outlet
Plug Peripherals into Slave Outlets
When the computer is turned off, the master outlet shuts off power to the slave outlets.
However, when the computer goes into sleep mode or the power consumption of connected
device to the master outlet is below 10 W, the master outlet may not properly recognize the
reduced power level.
NOTE
NOTICE
Plug the input power cable of the unit to the wall outlet. The Power indicator will light up when
the mains is normal. The Power indicator will turn off when there is a power failure.
1. The master/slave function is disabled by default. Ensure that the master/slave function switch is
on the disable status before operation.
2. Only when the master/slave function is enabled, loads connected to slave outlets will be shut
down after load is detected lower than 10 W in master outlet.
3. Master/slave function operation
:
After connecting all devices to the unit, turn the master/slave function switch to the enable status.
The slave on indicator will light up when the load connected to master outlet is above 30 W.
Turn the master/slave function switch to the disable status, the function is disabled and the slave
on indicator will be on.
