TP48200A-DT19C1 & DT19C2 & HT19C1 & HT19C2
Installation Guide
10 Commissioning
Issue 03 (2014-02-23)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
86
Main Menu
Second-
Level Menu
Third-Level
Menu
Default Value
Setting Value
Subnet Mask
255.255.255.0
Set this parameter according to
the subnet mask provided by the
network administrator.
Default Gateway
192.168.0.1
Set this parameter according to
the gateway address provided by
the network administrator.
----End
10.8.2 (Optional) Setting Parameters Before Using the NetEco
Management
Networking Mode 1: over FE Port
Step 1
Apply to the site or equipment room network administrator for a fixed IP address.
Step 2
Set the IP address, subnet mask, and gateway on the LCD, as shown in
Table 10-7
IP parameters
Main
Menu
Second-
Level Menu
Third-Level
Menu
Default Value
Setting
Setting
Wizard
Network
Parameters
IP Address
192.168.0.10
Set this parameter according to
the IP address assigned by the
network administrator.
Subnet Mask
255.255.255.0
Set this parameter according to
the subnet mask provided by the
network administrator.
Default Gateway
192.168.0.1
Set this parameter according to
the gateway address provided by
the network administrator.
Step 3
Set the
IP Addresses
and
Ports
for the active and standby servers of the NetEco on the LCD,
as described in
Table 10-8
NetEco parameters
Main
Menu
Second-
Level Menu
Third-Level
Menu
Fourth-Level
Menu
Default Value
Setting
Parameters
Settings
Comm.
Parameters
Network
Parameters
NetEco Primary IP
192.168.0.10
Set an IP address
for the active
NetEco server.
