Huawei TaiShan 200 2280, Maintenance And Service Manual

Page: 91 / 209

Step 6 Remove the other guide rail in the same way.
----End
5.4.4.2 Removing the Server and Adjustable Guide Rails
Step 1 Wear an ESD wrist strap. For details, see 5.2 ESD Protection .
Step 2 Power off the server. For details, see 5.4.2 Powering Off the Server .
Step 3 Disconnect all power cables and signal cables from the server.
Step 4 Remove the server.
1. Loosen the captive screws on the server panel using a screwdriver. See (1) in
Figure 5-11 .
Figure 5-11 Removing the server
2. Pull out the server along the guide rails away from the cabinet. See (2) in
Figure 5-11 .
3. Place the removed server on an ESD platform.
Step 5 Loosen the M6 screw from the lowest square hole at the rear of a guide rail. See
(1) in Figure 5-12 .
Step 6 Remove the two plugs from the middle square holes on both ends. See (2) in
Figure 5-12 .
Step 7 Slightly lift the guide rail, retract it from the square holes, and take it out. See (3)
and (4) in Figure 5-12 .
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 84