Procedure
Step 1
In global config mode, run the
interface h248
command to enter the MG interface mode.
Step 2
Run the
mg-software parameter 4
command to configure the registration mode.
Step 3
Run the
mg-software parameter 6 0
command to configure the MG interface to support the
device authentication.
Step 4
Run the
auth
command to configure the authentication MG ID and the initial key.
Step 5
Run the
display auth
command to query the device authentication parameters.
Step 6
Run the
reset coldstart
command to reset the MG interface.
----End
Example
To configure the device authentication parameters shown in the
for the MA5616,
do as follows:
Table 7-31
Data plan for configuring the authentication parameters (H.248)
Configuration Item
Value
MGID
0
Whether to use the wildcard in registration
Yes
Whether to support the device
authentication.
Yes
Authentication MG ID
MA5616
It must be the same as the configuration on the
MGC. Otherwise, the MG cannot register with
the MGC.
Initial key
Default: 0123456789ABCDEF.
It must be the same as the initial key configured
on the MGC.
huawei(config)#
interface h248 0
huawei(config-if-h248-0)#
mg-software parameter 4 0
huawei(config-if-h248-0)#
display mg-software parameter 4
-------------------------------------------------
Interface Id:0 para index:4 value:0
-------------------------------------------------
APPENDIX:
-------------------------------------------------
Interface software parameter name:
4: Whether MG uses wildcard in registration
0: Yes
1: No
huawei(config-if-h248-0)#
mg-software parameter 6 0
huawei(config-if-h248-0)#
display mg-software parameter 6
-------------------------------------------------
Interface Id:0 para index:6 value:0
SmartAX MA5616 Multi-service Access Module
Configuration Guide
7 Configuring the Voice Service
Issue 04 (2011-10-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
307
