Figure 3-8
Setting the line delay and the character delay
----End
Result
On the HyperTerminal interface, press
Enter
, and the system prompts you to enter the user
name. Enter the user name and the password for user registration (by default, the super user
name is
root
and the password is
mduadmin
), and wait until the CLI prompt character is
displayed. For instructions on CLI, see CLI Operation Characteristics.
If your login fails, click
and then click
on the operation interface. If your login still fails,
return to
to check the parameter settings and the physical connections, and then try again.
3.1.2 Configuring Outband Management
This topic describes how to connect the MA5616 to the maintenance terminal through an outband
management port, log in to the MA5616, and then manage the MA5616.
Prerequisites
l
You must log in to the system through a local serial port. For the configuration process,
see
3.1.1 Configuring Management Through a Local Serial Port
.
l
The IP address of the maintenance terminal must be properly configured.
NOTE
In the following operations, the configurations of the MA5616 must be performed through a local serial
port.
Networking - LAN
shows an example network for configuring outband management over a LAN in the
telnet mode.
SmartAX MA5616 Multi-service Access Module
Configuration Guide
3 Basic Configuration
Issue 04 (2011-10-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
18