Run the
display clock mode
command to query the working mode of the clock. Ensure
that the working mode of the clock daughter board is
Tracing
.
huawei(config)#
display clock mode
Clock manage-mode:Third-mode
Clock subboard work-mode:
Tracing
l
Configure the ONU-side clock.
1.
Configure the PON line clock as the system clock.
huawei(config)#
clock source 0 0/0/1
huawei(config)#
clock priority system 0
2.
Query the configuration and status of the system clock source.
Run the
display clock source
command to query the configuration and status of the
system clock source.
huawei(config-if-tdm-0/1)#
quit
huawei(config)#
display clock source
--------------------------------------------------------------------
Index Type Source State Priority QL Selected
--------------------------------------------------------------------
0 line 0/0/1 Normal 0 --- YES
1 -- -/ -/ - --- --- NO ---
2 -- -/ -/ - --- --- NO ---
3 -- -/ -/ - --- --- NO ---
4 -- -/ -/ - --- --- NO ---
5 -- -/ -/ - --- --- NO ---
6 -- -/ -/ - --- --- NO ---
7 -- -/ -/ - --- --- NO ---
8 -- -/ -/ - --- --- NO ---
9 -- -/ -/ - --- --- NO ---
--------------------------------------------------------------------
----End
14.4.5.6 Configuring E2E Reliability
This topic describes how to configure end-to-end (E2E) protection schemes for the enterprise
private line service which has a high requirement on service reliability.
Context
Reliability covers equipment reliability, upstream networking protection, and downstream
networking protection. For details on reliability data planning, see
.
l
Upstream networking protection includes link aggregation group and protection group.
Usually, link aggregation group is configured when the GIU board is used to transmit traffic
upstream; protection group is configured when the main control board is used to transmit
traffic upstream. The two protection schemes are not configured at the same time.
l
Downstream networking protection includes Type B, Type C single homing, and Type C
dual homing, which are used to protect service ports. Ports on the same ONU can be
configured only with the same protection scheme.
NOTE
This topic describes how to configure five mainstream protection schemes. Select required protection schemes
based on the carrier's requirement and actual networking scenario.
Procedure
l
Configure a link aggregation group.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1474