Figure 11-6
Tightening screws
2.
Connect the blue core wire labeled NEG(-) to the
-
port and the black/brown core wire
labeled RTN(+) to the
+
port on the tool-less female connector (pressfit type), and then
tighten the screws using a Phillips screwdriver, as shown in
.
Figure 11-7
Adding a tool-less female connector (pressfit type) to two core wires
Step 5
Strip the specified length of the sheath off the power cable to expose the intact shield layer, as
shown in
.
RRU3942&RRU3642
Installation Guide
11 Appendix
Issue 07 (2013-12-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
120
