NQA entry(admin, jitter) :testflag is inactive ,testtype is jitter
1 . Test 1 result The test is finished
SendProbe:60 ResponseProbe:60
Completion:success RTD OverThresholds number:0
OWD OverThresholds SD number:0 OWD OverThresholds DS number:0
Min/Max/Avg/Sum RTT:1/1/1/60 RTT Square Sum:60
NumOfRTT:60 Drop operation number:0
Operation sequence errors number:0 RTT Stats errors number:0
System busy operation number:0 Operation timeout number:0
Min Positive SD:1 Min Positive DS:1
Max Positive SD:1 Max Positive DS:1
Positive SD Number:3 Positive DS Number:1
Positive SD Sum:3 Positive DS Sum:1
Positive SD Square Sum:3 Positive DS Square Sum:1
Min Negative SD:1 Min Negative DS:1
Max Negative SD:1 Max Negative DS:1
Negative SD Number:3 Negative DS Number:1
Negative SD Sum:3 Negative DS Sum:1
Negative SD Square Sum:3 Negative DS Square Sum:1
Min Delay SD:0 Min Delay DS:0
Avg Delay SD:0 Avg Delay DS:0
Max Delay SD:0 Max Delay DS:0
Delay SD Square Sum:0 Delay DS Square Sum:0
Packet Loss SD:0 Packet Loss DS:0
Packet Loss Unknown:0 Average of Jitter:1
Average of Jitter SD:1 Average of Jitter DS:1
jitter out value:0.0062500 jitter in value:0.0020833
NumberOfOWD:60 Packet Loss Ratio: 0%
OWD SD Sum:0 OWD DS Sum:0
ICPIF value: 0 MOS-CQ value: 0
6.15 Configuring the MAC Ping Test
This section describes how to perform the MAC ping test with NQA.
6.15.1 Establishing the Configuration Task
6.15.2 Setting Parameters for the MAC Ping Test
6.15.3 Checking the Configuration
6.15.1 Establishing the Configuration Task
Applicable Environment
After you configure the MAC ping test, you can check the connectivity between two or more
devices by using the LBM and LBR packets defined by 802.1ag and collect statistics.
Pre-configuration Tasks
Before configuring the MAC ping test, complete the following task:
l
Enabling connectivity fault management (CFM) globally so that the maintenance
association end points (MEPs) of the same level can reside on the same VLAN
Data Preparation
To configure the MAC ping test, you need the following data.
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-42
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
