7.10.4 Configuring a VSI to Ignore the AC Status
When the services running on the old network will switch to the new network, you can configure
a VSI to ignore the AC status.
Context
Figure 7-10
Networking diagram of configuring a VSI to ignore the AC status
Devices on the old network
Server
A
B
C
D
A'
B'
C'
D'
DSLAM
Devices on the new network
, if the services running on the old network will switch to the new
network, and you want to check whether the VSI on the new network can work normally before
the service switchover, you need to configure the VSI to ignore the AC status on D'. After the
configuration, the VSI on D' keeps Up before the DSLAM is connected to the new network.
The AC statuses are classified into the following statuses:
l
The status of an physical AC interface or logical AC interface that is bound to the VSI
l
The UPE PW status in the scenario of VLL accessing VPLS
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
7 VPLS Configuration
Issue 01 (2011-07-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
720
