Install the Device/ 设备安装
2
D Indoor Ceiling-Mount/ 室内吊装
Fix the box camera to the ceiling-mount bracket.
将枪机固定到吊装支架上。
1
E Outdoor Pole-Mount/ 室外立杆抱装
3
Place the wall-mount bracket to
the installation position, and use
the marker to mark the locations
of installation holes, and install the
expansion bolts into the holes. Remove
the flat washer, spring washer, and
nuts.
使用记号笔绘制螺钉安装位置，并根据绘
制的螺钉安装位置钻孔。 使用羊角锤将膨
胀螺栓打入钻好的孔内。再将平垫、弹垫
和螺母拧下。
Install the ceiling-mount bracket.
安装吊装支架。
1
2
3
Install the wall-mount bracket to the pole-mount bracket.
将壁装支架安装到抱装支架上。
Use loops to install the pole-mount bracket to the pole.
使用抱箍将抱装支架安装到柱杆上。
Unfasten the screws on the universal joint to enable the universal joint
to rotate freely. Fix the shield on the universal joint, adjust the shield
position, and tighten all screws on the universal joint.
拧松万向节上的螺钉，使得万向节可以自由转动。将护罩固定到万向节上，调
整好护罩方位后，拧紧万向节上的所有螺钉。
F Outdoor Beam-Mount/ 室外横臂抱装
1
Use a hold hoop to install the pole-mount bracket on the cross
arm (refer to step 2 in
E Outdoor Pole-Mount
), install the universal
joint into No.2 hole on the pole-mount bracket, as shown in the
following figure (properly adjust the horizontal monitoring angle
during installation).
使用抱箍将抱装支架安装到横臂上（参见“室外立杆包装中的步骤 2），
然后将万向节安装到包装支架 2 号孔位（如下图，安装时注意调整好水
平监控角度）。
2
Unfasten the screws on the universal joint to enable the universal
joint to rotate freely. Fix the shield on the universal joint, adjust
the vertical monitoring angle, and tighten all screws on the
universal joint.
拧松万向节上的螺钉，使得万向节可以自由转动。将护罩固定到万向节
上，调整好垂直监控角度，拧紧万向节上的所有螺钉。
