l
Heavy stress, violent vibration or water splash are not allowed during transportation,
storage and installation.
l
The device needs to be installed in the location where professional staff can cover
(professionals need to know the attentions of using the device), non-professionals are not
allowed to enter device installation area when the device is operating normally, which
may cause accidental damage.
l
Ensure the network link quality during project construction and device installation.
l
When a camera is installed near the seaside or salt water lake, ensure that the camera is
more than 10 km away from the coastline and lake shoreline.
Operation and Daily Maintenance
l
Do not directly touch the heat dissipation component of the device to avoid scald.
l
Do not dismantle the device because there is no component that can be fixed by users
themselves. Otherwise, it might cause water leakage or bad image due to unprofessional
dismantling. Please contact after-sale service to replace desiccant when it becomes green.
(The desiccant is not provided by default)
l
It is advised to use the device together with lightning arrester to improve lightning
protection effect.
l
It is advised to get the grounding holes to be grounded to enhance the reliability of the
device.
l
Do not directly touch the optic component CCD or CMOS. You can use the air blower to
blow away the dust or dirt on the lens surface. Please use a dry cloth wetted by alcohol to
wipe away the dust gently if necessary.
l
Use the dry soft cloth to clean the device. If the dust is difficult to be removed, please
wipe it away with a clean cloth wetted slightly by the mild detergent, and then use the
dry cloth to clean the device. Do not use volatile solvents like alcohol, benzene, thinner,
or strong detergent with abrasiveness, otherwise it will damage the surface coating or
reduce the working performance of the device.
l
The IPC shield is a kind of optical component, please do not touch or wipe the shield
surface during installation and application, it may stain dust, grease or fingerprint, you
can use absorbent cotton to dip some diethyl ether or use soft cloth to dip some water
and then wipe gently. You can also use air gun to remove the dust if the shield is stained
with dust.
IPC6091-P360
Quick Start Guide
1 Important Safeguards and Warnings
Issue 01 (2019-02-22)
Copyright © Huawei Technologies Co., Ltd.
3
